Eotech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUM User Manual download pdf (Page 26)

2-4

2.3 MOUNTING PROCEDURES (Continued)

WARNING

Be sure the weapon is CLEAR and SAFE before

proceeding.

NOTE

The ATPIAL may be placed at any position

(forward and aft) on the rail that is most

convenient for the operator. However, the entire

length of the mounting surface must be fully

supported (in direct contact) by the MIL-STD-1913

rail. If the ATPIAL is removed from the rail, the

operator must make note of the position at which it

was boresighted or zeroed, and return it to that

same position in order to ensure that zero is

retained.

1. Loosen the mounting screw on the rail grabber bracket

until the jaws have sufficient space to fit over the weapon

rail.

2. Hold the ATPIAL with the laser apertures facing in the

direction of the muzzle of the weapon.

3. Position the ATPIAL on the rail ensuring the recoil lug is

seated in the desired recoil groove of the rail.

4. While pushing down and forward on the ATPIAL, turn the

mounting screw clockwise as tightly as fingers allow. Use

a screwdriver or similar tool in the slot of the mounting

screw to turn it an additional 1/2 turn.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 69 70

No comments

Eotech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUM User Manual Page 26