Eotech Holographic Hybrid Sight I EXPS3-4 with G33.STS Ma User Manual download pdf (Page 34)

2.6 Zeroing Procedures

Once the weapon’s iron sights have been zeroed, please refer to the section on Windage and Elevation

Adjustments (Section 2.1.6) to zero the HWS®. The following are some additional reference aids that

can be used during the zeroing process.

BORE SIGHTING

Bore sighting is a good preliminary procedure in achieving proper alignment of your sight to the

firearm. A chamber laser/ bore sighter is an aid in achieving collomation.

LIVE FIRE SIGHTING FOR AN M-4 OR M-16

To employ the aiming dot of the HWS® reticle from 10 to 300 meters, the sight can be zeroed at 25

meters using a standard M4/M16 military zeroing target. With the dot aimed at center mass of the

target, the sight should be adjusted so the round lands approximately 1 cm below the point of aim at

25 meters. This method of zeroing ensures hitting a target at 100-200 meters where fine tuning

should be conducted. Additionally there are custom targets for 25m zeroing used with the M-4 and

M16 (see Figure 7), and for Laser Bore Sighting (see Figure 8). Please visit the manufacturer’s website

at www.L-3com.com/EOTech or contact the manufacturer for copies of these targets.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Eotech Holographic Hybrid Sight I EXPS3-4 with G33.STS Ma User Manual Page 34