Eotech Holographic Hybrid Sight I EXPS3-4 with G33.STS Ma User Manual download pdf (Page 33)

2.5 Installation of Equipment

MOUNTING

The EXPS3 is equipped with mounting hardware (see Figure 6) to

attach to a 1” (25.4mm) Weaver or MIL-STD-1913 Picatinny style rail.

To achieve the best results and accuracy, the HWS® must be mount-

ed properly. The rail needs to be as parallel as possible to the bore

to permit the maximum elevation and windage adjustments. If it is

required, it is strongly recommend that the rail be installed by a

qualified gunsmith. To mount the sight, please follow these steps.

1. First, push the locking button inward, then turn the quick detach lever so it is away from its closed

and nested position in the base of the sight. The locking button must be pushed down before pulling

on the lever. This will expand the clamping interface to allow the sight to mount onto the rail.

2. The sight contains a small cross bolt that rests in the groove of the Picatinny rail. Move the sight

to the position desired on the rail and allow the post to rest fully in the closest groove.

3. Push the sight as far forward as possible and close the quick detach lever so it is fully shut and

nested in the base of the sight.

4. If at first the sight does not appear to be secure or the lever does not fully close, turn the adjust-

ment nut opposite the quick detach lever clockwise for a tighter fit, and counterclockwise to accom-

modate wider rail tolerances.

Figure 6

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Eotech Holographic Hybrid Sight I EXPS3-4 with G33.STS Ma User Manual Page 33